Durango 2WD V6-3.7L (2009)
11. Remove the tape or plugs from the liquid line fitting and the receiver/drier (3).
12. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it onto the liquid line fitting. Use only the specified O-ring as it is made of
a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
13. Connect the rear section of the A/C liquid line (2) to the receiver/drier.
14. Install the bolt (1) that secures the rear section of the A/C liquid line to the receiver/drier. Tighten the bolt to 11 Nm (97 in. lbs.).
15. On Hybrid Electric Vehicle (HEV) models, install the Traction Power Inverter Module (TPIM) (1) and mounting bracket (2) .
16. Install the TPIM coolant recovery bottle .
17. Install the rear section of the liquid line (2) into the plastic retainer (3) located on the right inner fender (4).
18. Install the air cleaner housing and resonator (1) See: Filters/Air Cleaner Housing/Service and Repair/Air Cleaner Body - Installation.
