Durango 2WD V6-3.7L (2009)
Wheel Bearing: Service and Repair
Front Hub and Bearing - Installation
INSTALLATION
1. Install the brake dust shield (2).
2. Install the hub/bearing (1) into the steering knuckle (3) and tighten the bolts (5) to 163 Nm (120 ft. lbs.).
3. Install the brake rotor and caliper See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and
Replacement/Brake Rotor - Installation.
4. Install the ABS wheel speed sensor (4) if equipped See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Wheel Speed
Sensor/Service and Repair/Wheel Speed Sensor - Installation/Front.
5. Install the upper ball joint nut to the steering knuckle and tighten to 75 Nm (55 ft. lbs.).
6. Install the tie rod end nut to the steering knuckle and tighten to 75 Nm (55 ft. lbs.).
7. Install the halfshaft nut and tighten to 251 Nm (185 ft. lbs.) 4X4 only.
8. Install the wheel and tire assembly See: Service and Repair/Removal and Replacement.
9. Remove the support and lower vehicle.