Durango 2WD V6-3.7L (2009)
Intake Air Temperature Sensor: Service and Repair
Removal
3.7L
The intake manifold air temperature (IAT) sensor (1) is installed into the air intake resonator (3) near the throttle body sealing gasket (2).
1. Remove air intake resonator (3) from throttle body.
2. Disconnect electrical connector from IAT sensor (1).
3. Clean dirt from resonator at sensor base.
4. Gently lift on small plastic release tab (3) and rotate sensor about 1/4 turn counter-clockwise for removal.
5. Check condition of sensor O-ring (2).
