Durango 2WD V6-3.7L (2009)
EGR Valve: Service and Repair
Exhaust Gas Recirculation (EGR) Valve - Removal
REMOVAL
The electronic EGR valve and solenoid assembly (1) is attached to the rear of the left cylinder head.
1. Use a diagnostic scan tool to record any DTC's (Diagnostic Trouble Codes).
2. Disconnect and isolate the negative battery cable.
3. Remove the plastic windshield cowl panel.
4. Remove the windshield wiper motor.
An exhaust gas routing tube (1) connects the EGR valve (4) to the intake manifold.
5. Remove the EGR routing tube retainers (2).
6. Remove the routing tube (1) from the solenoid (4) and slip the opposite end of the tube (6) out of the intake manifold.
7. Remove the gasket (3) located between the EGR valve solenoid and the routing tube flange.
