Durango 2WD V6-3.7L (2009)
CAUTION: Do not probe the PCM harness connectors. Probing the PCM harness connectors will damage the PCM terminals resulting in
poor terminal to pin connection. Install PCM Pinout Box 8815 to perform diagnosis.
2. Using a 12 volt test light connected to Ground, check the PCM Fused B+ circuits.
3. Wiggle test each circuit during the test to check for an intermittent open in the circuit.
NOTE: The test light should be illuminated and bright with the ignition on and not illuminated with the ignition off. Compare the brightness
to that of a direct connection to the battery.
Is the test light illuminated as described above?
Yes
-
Test complete.
No
-
Repair the open or short to ground in the PCM Fused B+ circuit(s) for as necessary.
-
Perform the POWERTRAIN VERIFICATION TEST. See: Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code
Tests and Associated Procedures/Verification Tests/Powertrain Verification Test.
