Durango 2WD V6-3.7L (2009)
Control Module: Removal and Replacement
Transmission Control Module - Removal
REMOVAL
WARNING: Be certain the procedure for the high voltage check-out has been performed and the service disconnect has been disconnected.
Failure to follow these instructions may result in serious or fatal injury.
NOTE: If the TECHM is being flashed, removed or replaced, it is necessary to perform the Resolver Offset Learn Trigger procedure using
the scan tool.
1. Hoist and support vehicle on safety stands.
2. Place a large diameter shallow drain pan beneath the transmission pan.
3. Remove the drain plug, if equipped.
4. Remove the auxiliary oil pump mounting bolts (1).
5. Remove the auxiliary oil pump (2).
6. Remove the transmission oil pan (1), the primary oil filter (2) and the auxiliary oil filter (3).
