Durango 2WD V6-3.7L (2009)
possible serious or fatal injury.
1. Position the second row center seat belt buckle anchor (1) to the right seat back hinge bracket (2). Be certain the anti-rotation tab on the anchor is
engaged in the clearance hole of the bracket.
2. Install and tighten the screw (3) that secures the anchor to the bracket. Tighten the screw to 43 Nm (32 ft. lbs.).
3. Position the center seat back right hinge bracket cover (1) onto the bracket (2).
4. Install and tighten the three screws (3) that secure the cover to the bracket. Tighten the screws to 2 Nm (20 in. lbs.).
5. Unfold and restore the right outboard second row seat to its upright position.
Second Row - Outboard
SECOND ROW - OUTBOARD
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar (R) Parts Catalog. Failure to follow these instructions may result in
possible serious or fatal injury.
