Durango 2WD V6-3.7L (2009)
4. Remove the two screws (3) that secure the belt web guide bezel (2) to the top of the center seat back panel and remove the bezel from the seat
back and the belt.
5. Remove the trim cover (1) from the center seat back. See: Body and Frame/Seats/Seat Cover/Service and Repair/Seat Back Cover - Removal.
6. Remove the three screws (3) that secure the retractor (2) to the seat back frame (1).
7. Lift the retractor upward far enough to disengage the two tabs (4) on the retractor bracket from the keyed slots in the seat back frame.
8. Remove the second row seat belt and retractor from between the seat back foam and frame as a unit.
Second Row - Outboard
SECOND ROW - OUTBOARD
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar (R) Parts Catalog. Failure to follow these instructions may result in
possible serious or fatal injury.
