Durango 2WD V6-3.7L (2009)
1. Check to be certain that the rivet nut (3) used to secure the side impact sensor (2) is properly installed in the quarter inner panel, and that it is in
good condition.
2. Position the side impact sensor near the quarter inner panel.
3. Reconnect the body wire harness (4) connector to the sensor connector receptacle.
4. Position the sensor onto the quarter inner panel. Be certain that the anti-rotation pin on the back of the sensor is engaged in the clearance hole of
the quarter inner panel.
5. Install and tighten the screw (1) that secures the sensor to the quarter inner panel. Tighten the screw to 6 Nm (50 in. lbs.).
6. Reinstall the quarter trim panel onto the quarter inner panel near the lower C-pillar (5). See: Body and Frame/Interior Moulding / Trim/Trim
Panel/Service and Repair/Luggage Compartment Trim/Quarter Trim Panel - Installation.
7. Do not reconnect the battery negative cable at this time. On vehicles equipped with the optional Hybrid Electric Vehicle (HEV) system, the service
disconnect must also remain disconnected from the high voltage battery pack. The Supplemental Restraint System (SRS) verification test
procedure should be performed following service of any SRS component. See: Service and Repair.
