Durango 2WD V6-3.7L (2009)
Seat Position Sensor: Service and Repair
Seat Track Position Sensor - Removal
REMOVAL
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component
diagnosis or service. Disconnect and isolate the negative battery (ground) cable. Wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. On vehicles equipped with the optional Hybrid Electric Vehicle (HEV)
system, a technician trained in proper HEV service safety procedures must also remove the high voltage service disconnect from
the high voltage battery pack. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in
accidental airbag deployment. Failure to follow these instructions may result in possible serious or fatal injury.
1. Disconnect and isolate the battery negative cable. On vehicles equipped with the optional Hybrid Electric Vehicle (HEV) system, a technician
trained in proper HEV service safety procedures must also remove the high voltage service disconnect from the high voltage battery pack. Wait
two minutes for the system capacitor to discharge before further service.
2. Reach under the front seat cushion to access the seat track position sensor (4) in a bracket (1) located on the inboard side of either the inner or
outer, driver or passenger seat track (5).
3. Disconnect the seat wire harness connector (3) from the sensor connector receptacle located on the end of the sensor.
4. Using a small screwdriver, depress the snap feature (2) and pull the connector end of the sensor out of the bracket.
5. Remove the sensor from under the front seat.
