Durango 2WD V6-3.7L (2009)
Tie Rod End: Service and Repair
Tie Rod End - Removal
Outer Tie Rod End
OUTER TIE ROD END
NOTE: Do not twist the boot anytime during removal or installation.
1. Loosen the jam nut (3).
2. Remove the outer tie rod end (2) nut (1) from the ball stud.
3. Separate the outer tie rod end (2) from the knuckle with Remover 8677 (1).
4. Unthread the outer tie rod end from the inner tie rod. Count the number of turns when removing the tie rod end, This will give a good
starting point when reassembling and toe adjustment.
Inner Tie Rod End
INNER TIE ROD END