Durango 2WD V6-3.7L (2009)
6. Subtract smaller figure from larger (C minus A) to obtain transmission output operating angle.
7. Rotate propeller shaft 90 degrees and place Inclinometer 7663 on pinion yoke bearing cap parallel to the shaft. Center bubble in sight glass and
record measurement (B).
This measurement will give you the pinion shaft or input yoke angle (B).
8. Subtract smaller figure from larger (C minus B) to obtain axle Input Operating Angle.
PROPELLER SHAFT ANGLE RULES
-
Good cancellation of U-joint operating angles is within 1 degree.
-
Operating angles less than 3 degrees.
-
At least 1/2 of one degree continuous operating (propeller shaft) angle.
