Durango 2WD V8-4.7L (2008)
3. Allow end of adhesive bead (1) to run out parallel to the start of the bead and smooth ends flush.
4. Lift backlite into place in the center of the liftgate opening and use the tape as a guide to aid installation of the backlite into the center of the
cutout.
5. Carefully lay down the backlite and press on.
CAUTION: It is no longer possible to move the backlite after installation. The backlite should never be pressed into place by more than
one person, because the backlite can break if pressed simultaneously on both sides.
CAUTION: Roll down the left and right front door glass and open the rear glass slider (if available) before installing backlite to avoid
pressurizing the passenger compartment if a door is slammed before urethane is cured. Water leaks can result.
6. Install the rear wiper arm, if equipped. See: Wiper and Washer Systems/Wiper Arm/Service and Repair/Wiper Arms - Installation
7. Install the liftgate trim panels.
8. Install the center stop light, See: Lighting and Horns/Center Mounted Brake Lamp/Service and Repair/Center High Mounted Stop Lamp -
Installation.
