Durango 2WD V8-4.7L (2008)
1. Install the caliper adapter mounting bolts (4). Tighten the mounting bolts to 135 Nm (100 ft.lbs).
2. Install the anti-rattle clips (2).
3. Install the inboard and outboard pads (1).
4. Install the caliper mounting bolts.
5. Install the tire and wheel assembly.
Removal
REMOVAL
1. Remove wheel and tire assembly.
2. Remove the disc brake caliper (3) See: Disc Brake Caliper - Removal.
3. Remove the caliper adapter (2) See: Disc Brake Caliper Adapter - Removal.
4. Remove the rotor (1) See: Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and Replacement/Brake Rotor - Removal.
5. Remove the axle shaft (1) See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Axle Shaft/Service and
Repair/Removal.