Durango 2WD V8-4.7L (2008)
4. Reconnect the electrical connector (4) for the low fluid level switch.
5. Fill and bleed the base brake system. See: Brake Bleeding.
With ESP
WITH ESP
NOTE: If master cylinder is replaced bleed cylinder before installation.
NOTE: Make sure the output rod (4) of the brake booster is in position and retained by a output rod retaining ring, by looking into the
boosters master cylinder mounting hole. This position will enable the output rod to enter inside of the master cylinder plunger sleeve during
installation. Proper position is obtained when the output rod is centered perpendicular to the master cylinder mounting hole.
NOTE: Prior to installing the master cylinder assembly (2) check that there is a vacuum seal present at the shoulder of the master cylinder
flange and its neck. A round seal must be present to ensure vacuum integrity with the booster.
1. Gently install the master cylinder (2) on the booster mounting studs (3).
NOTE: Take precautions to locate the master cylinder plunger over the booster output rod, before installing the master cylinder. If
correctly fitted the master cylinder should slide easily onto the booster output rod before the mounting studs are engaged in the flange
holes of the master cylinder.
2. Install the IPM (1) back in place and install the fasteners for the IPM (1)
3. Install the left front wheel well.
