Durango 2WD V8-4.7L (2008)
9. Connect the HVAC wire harness connector (1) to the blend door actuator. Make sure the wire harness is properly secured to the bottom of the
HVAC housing.
10. Reconnect the negative battery cable.
11. Initiate the Actuator Calibration function using a scan tool See: Testing and Inspection/Component Tests and General Diagnostics/HVAC System
Test or See: Testing and Inspection/Component Tests and General Diagnostics/HVAC System Test.
Rear Controls
INSTALLATION
1. Position the rear blend door actuator (1) onto the side of the rear HVAC housing (2). If necessary, rotate the actuator slightly to align the splines
on the actuator output shaft (3) with those on the rear actuator coupler (4).
2. Install the screws (4) that secure the rear blend door actuator (2) to the rear HVAC housing (3). Tighten the screws to 2 Nm (17 in. lbs.).
3. Connect the rear HVAC wire harness connector (1) to the rear blend door actuator.
4. Install the right rear quarter panel trim See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Quarter Panel Trim/Quarter
Trim Panel - Installation.
5. Reconnect the negative battery cable.
6. Initiate the Actuator Calibration function using a scan tool See: Testing and Inspection/Component Tests and General Diagnostics/HVAC System
Test or See: Testing and Inspection/Component Tests and General Diagnostics/HVAC System Test.
Front Controls
REMOVAL
WARNING: On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, or instrument
panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system
capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the
proper precautions could result in accidental airbag deployment and possible personal injury or death.