Durango 2WD V8-4.7L (2008)
1. Disconnect and isolate the battery negative cable.
2. Remove the center bezel (1) from the instrument panel. See: Dashboard / Instrument Panel/Service and Repair/Instrument Panel Center Bezel -
Removal.
3. Use a small thin-bladed screwdriver to rotate the bulb holder (3) counterclockwise about 30 degrees to unlock it from the keyed opening in the
front A/C-heater control (2) circuit board.
4. Pull the bulb holder and bulb straight out of the circuit board.
Bulb - Rear A/C-Heat Control
BULB - REAR A/C-HEAT CONTROL
1. Disconnect and isolate the battery negative cable.
2. Remove the rear A/C-heater control from the center floor console. See: Heating and Air Conditioning/Control Assembly/Service and Repair/A/C
Heater Control - Removal/Front Control See: Heating and Air Conditioning/Control Assembly/Service and Repair/A/C Heater Control -
Removal/Rear Control.
3. Use a small thin-bladed screwdriver to rotate the bulb holder (2) counterclockwise about 30 degrees to unlock it from the keyed opening in rear
A/C-heater control (1) circuit board.
4. Pull the bulb holder and bulb straight out of the circuit board.
