Durango 2WD V8-4.7L (2008)
Brake Light Switch: Description and Operation
Stop Lamp Switch
Description
DESCRIPTION
The brake lamp switch (2) is a three circuit, spring-loaded plunger actuated switch that is secured to the steering column support bracket under the
instrument panel on the driver side of the vehicle. The molded plastic switch housing has an integral connector receptacle (1) containing six terminal pins
and featuring a Connector Position Assurance (CPA) lock. The switch is connected to the vehicle electrical system through a dedicated take out of the
instrument panel wire harness.
The switch plunger (3) extends through a mounting collar (4) on one end of the switch housing. The plunger has a one time telescoping self-adjustment
feature that is activated after the switch is installed by moving an adjustment release lever (5) on the opposite end of the switch housing clockwise, until
it locks into a position that is horizontal and parallel to the connector receptacle.
An installed brake lamp switch cannot be readjusted or repaired. If the switch is damaged, ineffective, or removed from its mounting position for any
reason, it must be replaced with a new unit.
Operation
OPERATION
The brake lamp switch controls three independent circuits. These circuits are described as follows:
-
Brake Lamp Switch Circuit - A normally open brake lamp switch circuit receives a battery voltage input, and supplies this battery voltage to the
brake lamps and the Controller Antilock Brake (CAB) on a brake lamp switch output circuit only when the brake pedal is depressed (brake lamp
switch plunger released).
-
Brake Lamp Switch Signal Circuit - A normally closed brake lamp switch signal circuit receives a direct path to ground, and supplies this
ground input to the Powertrain Control Module (PCM) on a brake lamp switch sense circuit only when the brake pedal is released (brake lamp
switch plunger is depressed).
-
Speed Control Circuit - A normally closed speed control circuit receives a battery voltage input from the Powertrain Control Module on a speed
control supply circuit, and supplies this battery voltage to the speed control servo solenoids (dump, vacuum, and vent) on a speed control brake
switch output circuit only when the speed control system is turned ON and the brake pedal is released (brake lamp switch plunger is depressed).
The components of the self-adjusting brake switch plunger consist of a two-piece telescoping plunger, a split plunger locking collar, and a release wedge.
The release lever has a shaft with a wedge that spreads the plunger locking collar to an open or released position. After the switch is installed and the
brake pedal is released, the plunger telescopes to the correct adjustment position. When the release lever is moved to the release position, the wedge is
disengaged from the locking collar causing the collar to apply a clamping pressure to the two plunger halves, fixing the plunger length.
The brake lamp switch as well as the hard wired inputs and outputs of the switch may be diagnosed using conventional diagnostic tools and procedures.
Refer to the appropriate wiring information.
