Durango 2WD V8-4.7L (2008)
Wiper Control Module: Customer Interest
Wipers/Washers - Wipers Won't Return to Park Position
NUMBER: 08-023-08
GROUP: Electrical
DATE: July 22, 2008
SUBJECT:
Wipers Will Not Return To Park Position
OVERVIEW:
This bulletin involves diagnosis and if necessary, replacement of Front Windshield Wiper Motor.
MODELS:
2008
(HB)
Durango
2008
(HG)
Aspen
NOTE:
This bulletin applies to vehicle built from December 17, 2007 (MDH1217XX) to January 31, 2008 (MDH0131XX).
SYMPTOM/CONDITION:
The customer may experience the windshield wipers do not return to the "Park position when the switch is turned off.
Further investigation may show a DTC in the Front Control Module Central Gateway (FCMCG) - B2305 - Wiper Park Switch Input Circuit High (Stuck
High).
DIAGNOSIS:
Using a Scan Tool (StarSCAN(R)) with the appropriate Diagnostic Procedures available in TechCONNECT, verify all electrical systems are functioning
as designed. If DTC's other than those listed above are present record them on the repair order and repair as necessary before proceeding further with this
bulletin.
If the above symptom/condition is experienced and the vehicle was built from December 17, 2007 to January 31, 2008, perform the Repair Procedure.
PARTS REQUIRED:
REPAIR PROCEDURE:
1.
Replace the front windshield wiper module using p/n 55077411AF. Refer to TechCONNECT for detailed repair procedures. From the Service
Info tab select: 8 - Electrical > Wipers/Washers - Service Information > Transmission, Wiper > Removal and Installation.
2.
Verify proper operation of Front Windshield Wipers. Do Front Wipers operate and park as designed?
a.
Yes >>> Repair is complete.
b.
No >>> Further diagnosis is required. Refer to the diagnostic information available in DealerCONNECT > TechCONNECT.
POLICY:
Reimbursable within the provisions of the warranty.
