Durango 2WD V8-4.7L Flex Fuel (2009)
1. Raise and support the vehicle
2. Remove the tire and wheel assembly.
3. Remove the disc brake caliper See: Brake Caliper/Service and Repair/Removal and Replacement/Disc Brake Caliper - Removal.
4. Remove the caliper adapter bolts.See: Brake Caliper/Service and Repair/Removal and Replacement/Disc Brake Caliper Adapter - Removal
5. Remove the disc brake caliper adapter (2).
6. Remove the retaining clips and rotor assembly (1).
Front
FRONT
1. On models with all-wheel antilock system (ABS), check condition of tone wheel on hub/bearing. If teeth on wheel are damaged, hub/bearing
assembly will have to be replaced (tone wheel is not serviced separately).
2. Install the rotor (1) onto the hub/bearing wheel studs (2).
3. Install the caliper adapter assembly (2),See: Brake Caliper/Service and Repair/Removal and Replacement/Disc Brake Caliper - Installation and
tighten adapter bolts to 176 Nm (130 ft.lbs.).
4. Install the wheel and tire assembly, See: Maintenance/Wheels and Tires/Service and Repair/Removal and Replacement and lower the vehicle.
5. Apply the brakes several times to seat brake pads. Be sure to obtain firm pedal before moving vehicle.