Durango 2WD V8-4.7L Flex Fuel (2009)
5. Raise the transmission enough to remove the through bolt (Manual transmission and 4x2 automatic transmission only).
6. Raise the transmission and remove the bolts retaining the mount to the crossmember (4x4 automatic transmission only).
7. Remove the two nuts retaining the isolator to the crossmember (Manual transmission and 4x2 automatic transmission only).
8. Remove the bolts (two bolts manual transmission)(three bolts 4x2 automatic transmission) retaining the insulator bracket to the transmission.
Front
REMOVAL
2WD
1. Disconnect the negative cable from the battery.
CAUTION: Remove the viscous fan (If Equipped) before raising engine. Failure to do so may cause damage to the fan blade, fan clutch and
fan shroud.
2. Remove the cooling fan.
3. Remove the engine oil filter.
4. Remove the oil drain trough.
5. Install the Engine Support 8534B (1).
