Durango 2WD V8-4.7L Flex Fuel (2009)
Air Door Actuator / Motor: Service and Repair
Mode Door Actuator - Installation
Front
INSTALLATION
1. Position the mode door actuator(s) (1) onto the driver side end of the HVAC housing as required. If necessary, rotate the actuator slightly to align
the splines on the actuator output shaft with those in the mode-air door linkage.
2. Install the screws (5) that secure the panel door actuator (2) and the floor/defrost door actuator (3) to the HVAC housing (4) as required. Tighten
the screws to 2 Nm (17 in. lbs.).
3. Connect the HVAC wire harness connector (1) to the mode door actuator(s) as required.
4. Reconnect the negative battery cable.
5. Initiate the Actuator Calibration function using a scan tool See: Testing and Inspection/Component Tests and General Diagnostics/HVAC System
Test.
Rear
INSTALLATION