Durango 2WD V8-4.7L Flex Fuel (2009)
Blower Motor: Service and Repair
Removal - Front
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable and wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow
these instructions may result in accidental airbag deployment and possible serious or fatal injury.
1. Disconnect and isolate the negative battery cable.
2. Remove the right front door scuff plate See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Description and Operation.
3. Remove the right cowl side trim panel.
4. Disconnect the wire harness connector (1) from the blower motor (2).
5. Remove the three screws (3) that secure the blower motor and blower wheel assembly to the HVAC housing (4).
6. Remove the blower motor and blower wheel assembly from the HVAC housing.
