Durango 2WD V8-4.7L Flex Fuel (2009)
18. Install the foam seal (1) to the flange on the HVAC housing.
19. If equipped with front dual zone automatic temperature control (ATC) system, install the driver side blend door actuator (2), cover and retaining
screws (1) onto the bottom of the HVAC housing (3) and connect the HVAC wire harness (4) See: Air Door/Air Door Actuator / Motor/Service
and Repair/Blend Door Actuator - Installation.
20. Align the two actuator couplers (1) with the mode-air door pivot shafts and install the couplers into the left side of the HVAC housing. Be sure to
install the couplers with the coupler arm located between the two stop tabs on the HVAC housing.
21. Install the blend door actuator (3) and the mode door actuators (4) and retaining screws onto the HVAC housing (5) See: Air Door/Air Door
Actuator / Motor/Service and Repair/Blend Door Actuator - Installation and See: Air Door/Air Door Actuator / Motor/Service and Repair/Mode
Door Actuator - Installation.