Durango 2WD V8-4.7L Flex Fuel (2009)
Center Mounted Brake Lamp Bulb: Service and Repair
Center Mounted Brake Lamp Bulb - Installation
BULB
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
1. Align the base of the bulb with the CHMSL socket (3).
2. Push the bulb straight into the socket until the base is firmly seated.
3. Align the socket and bulb with the keyed opening on the back of CHMSL housing (1).
4. Insert the socket and bulb into the housing until the socket is firmly seated.
5. Rotate the socket clockwise about 30 degrees to lock it into place.
6. Reconnect the wire harness connector (2) to the socket.
7. Reinstall the CHMSL onto the liftgate header panel. See: Service and Repair/Center Mounted Brake Lamp - Installation.
8. Reconnect the battery negative cable. On vehicles equipped with the optional Hybrid Electric Vehicle (HEV) system, a technician trained in
proper HEV service safety procedures must also reinstall the high voltage service disconnect into the high voltage battery pack.
