Durango 2WD V8-4.7L Flex Fuel (2009)
Headlamp Switch: Service and Repair
Headlamp Switch - Installation
INSTALLATION
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component
diagnosis or service. Disconnect and isolate the negative battery (ground) cable. Wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. On vehicles equipped with the optional Hybrid Electric Vehicle (HEV)
system, a technician trained in proper HEV service safety procedures must also remove the high voltage service disconnect from
the high voltage battery pack. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in
accidental airbag deployment. Failure to follow these instructions may result in possible serious or fatal injury.
1. Position the headlamp switch (2) to the back of the cluster bezel (1).
2. Install and tighten the three screws (3) that secure the headlamp switch to the cluster bezel. Tighten the screws to 2 Nm (17 in. lbs.).
3. Position the cluster bezel close enough to the instrument panel to reconnect the wire harness connector to the back of the headlamp switch.
4. Reinstall the cluster bezel onto the instrument panel. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Instrument Cluster Bezel - Installation.
5. Reconnect the battery negative cable. On vehicles equipped with the optional Hybrid Electric Vehicle (HEV) system, a technician trained in
proper HEV service safety procedures must also reinstall the high voltage service disconnect into the high voltage battery pack.