Durango 2WD V8-4.7L Flex Fuel (2009)
Engine Control Module: Removal and Replacement
Powertrain Control Module - Removal
REMOVAL
CAUTION: Certain ABS systems rely on having the Powertrain Control Module (PCM) broadcast the Vehicle Identification Number (VIN)
over the bus network. To prevent problems of DTCs and other items related to the VIN broadcast, it is recommend that you
disconnect the ABS CAB (controller) temporarily when replacing the PCM. Once the PCM is replaced, write the VIN to the PCM
using the scan tool. This is done from the engine main menu. Arrow over to the second page to "1. Miscellaneous". Select "Check
VIN" from the choices. Make sure it has the correct VIN entered before continuing. When the VIN is complete, turn off the
ignition key and reconnect the ABS module connector. This will prevent the setting of DTCs and other items associated with the
lack of a VIN detected when you turn the key ON after replacing the PCM.
CAUTION: Use the scan tool to reprogram the new PCM with the vehicles original identification number (VIN) and the vehicles original
mileage. If this step is not done, a Diagnostic Trouble Code (DTC) may be set.
The PCM (2) is attached to the right-front inner fender (1) located in the engine compartment.
To avoid possible voltage spike damage to the PCM, ignition key must be off, and negative battery cable must be disconnected before unplugging PCM
connectors.
1. Disconnect and isolate the negative battery cable.
2. Remove both wiper arms. See: Wiper and Washer Systems/Wiper Arm/Service and Repair/Wiper Arm - Removal.
3. Remove wiper cowl (two screws, four pins).
4. Remove wiper cowl support (three bolts).
5. Remove air intake tube (four nuts).
6. Carefully unplug the four 38-way connectors (3) from PCM.
7. Remove three PCM mounting bolts (4), and remove PCM from vehicle.
Powertrain Control Module - Installation
INSTALLATION
CAUTION: Certain ABS systems rely on having the Powertrain Control Module (PCM) broadcast the Vehicle Identification Number (VIN)
over the bus network. To prevent problems of DTCs and other items related to the VIN broadcast, it is recommend that you
disconnect the ABS CAB (controller) temporarily when replacing the PCM. Once the PCM is replaced, write the VIN to the PCM
using the scan tool. This is done from the engine main menu. Arrow over to the second page to "1. Miscellaneous". Select "Check
VIN" from the choices. Make sure it has the correct VIN entered before continuing. When the VIN is complete, turn off the
ignition key and reconnect the ABS module connector. This will prevent the setting of DTCs and other items associated with the
lack of a VIN detected when you turn the key ON after replacing the PCM.
CAUTION: Use the scan tool to reprogram the new PCM with the vehicles original identification number (VIN) and the vehicles original
mileage. If this step is not done, a Diagnostic Trouble Code (DTC) may be set.
