Durango 2WD V8-4.7L Flex Fuel (2009)
Seat Belt Height Adjuster: Service and Repair
Seat Belt Turning Loop Adjuster - Removal
SECOND ROW - OUTBOARD
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar (R) Parts Catalog. Failure to follow these instructions may result in
possible serious or fatal injury.
1. Unsnap the upper edge of the trim cover (3) from the second row outboard seat belt turning loop (1) and disengage the tab (2) on the lower edge of
the cover to access the turning loop screw.
2. Remove the screw (3) that secures the seat belt turning loop (4) to the height adjuster (1) on the upper C-pillar (5).
3. Remove the seat belt turning loop from the height adjuster.
4. Remove the upper trim (2) from the inside of the C-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/C-Pillar Trim Panel-Removal.
