Durango 2WD V8-4.7L Flex Fuel (2009)
Windshield Washer Spray Nozzle: Service and Repair
Washer Nozzle - Installation
Front
FRONT
1. Position the front washer nozzle (1) near the mounting hole on the outside of the hood panel (2).
2. Reconnect the washer hose to the barbed nipple of the nozzle.
3. Insert the nozzle into the mounting hole.
4. Using hand pressure, push firmly and evenly on the top of the nozzle until the integral latches lock into place on the underside of the outer hood
panel.
Rear
REAR
NOTE: The rear washer nozzle latch feature is a one time component, and will be damaged if the nozzle is removed from its mounting hole for
service. If removed from its mounting hole for any reason, the rear washer nozzle must be replaced with a new unit.
1. Position the new rear washer nozzle (2) to the mounting hole in the liftgate outer panel (3). Be certain that the rubber gasket is in position on the
back of the nozzle.
2. Reconnect the washer hose (1) to the barbed nipple on the back of the nozzle.
3. Push the hose and nozzle nipple into the mounting hole in the liftgate outer panel and engage the tab located above the nipple with the upper edge
of the hole.
4. Using hand pressure, push firmly and evenly on the lower edge of the nozzle until it snaps into place.