Durango 2WD V8-4.7L VIN N (2001)
Amplifier: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the trim cover from the right cowl side inner panel.
3. Disconnect the two instrument panel wire harness connectors from the connector receptacles on the bottom of the power amplifier.
4. Remove the three screws that secure the power amplifier to the right cowl side inner panel.
5. Remove the power amplifier from the right cowl side inner panel.
INSTALLATION
1. Position the power amplifier to the right cowl side inner panel.
2. Install the three screws that secure the power amplifier to the right cowl side inner panel. Tighten the screws to 2 Nm (17 in. lbs.).
3. Reconnect the two instrument panel wire harness connectors to the connector receptacles on the bottom of the power amplifier.
4. Install the trim cover onto the right cowl side inner panel.
5. Reconnect the battery negative cable.
