Durango 2WD V8-4.7L VIN N (2001)
Fig. 6
11. If the vehicle is equipped with a glove box lamp, pull the glove box module away from the instrument panel far enough to access and disconnect
the instrument panel wire harness connector from the glove box lamp and switch connector receptacle (Fig. 6).
12. Remove the glove box module from the instrument panel.
DISASSEMBLY
The glove box latch and handle unit of the glove box used in this vehicle are serviced individually. The following is the procedure for disassembling this
component.
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING
WHEEL, STEERING COLUMN, SEAT BELT TENSIONER, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE.
DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG
SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE
WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL
AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
1. Remove the glove box door from the glove box module.
2. Remove the nine screws that secure the flanges around the perimeter of the glove box bin to the inside of the glove box door.
Fig. 7
3. Remove the glove box bin from the inside of the glove box door (Fig. 7).
