Durango 2WD V8-4.7L VIN N (2001)
Brake Master Cylinder: Service and Repair
Master Cylinder Removal and Installation
REMOVAL
Master Cylinder
(1) Remove brake lines from the master cylinder.
(2) Remove mounting nuts from the master cylinder.
(3) Remove master cylinder.
INSTALLATION
NOTE: If master cylinder is replaced bleed cylinder before installation.
(1) Install the master cylinder on booster mounting studs.
(2) Install the mounting nuts and tighten to 18 Nm (160 inch lbs.)
(3) Install the brake lines and tighten to 19 Nm (170 inch lbs.)
(4) Fill and bleed the base brake system
