Durango 2WD V8-4.7L VIN N (2001)
CAUTION: When installing the serpentine accessory drive belt, belt must be routed correctly. If not, engine may overheat due to water pump
rotating in wrong direction. Refer to figure for correct belt routing. Or, refer to the Belt Routing Label located in the engine compartment. The
correct belt with correct length must be used.
6. Position upper fan shroud and fan blade/viscous fan drive assembly.
7. Be sure the upper and lower portions of the fan shroud are firmly connected. All air must flow through the radiator.
8. Install two fan shroud-to-radiator screws.
9. Be sure of at least 25 mm (1.0 inches) between tips of fan blades and fan shroud.
10. Install fan blade/viscous fan drive assembly to water pump shaft.
11. Fill cooling system.
12. Connect negative battery cable.
13. Start and warm the engine. Check for leaks.
