Durango 2WD V8-4.7L VIN N (2001)
10. Remove damper using Special Tools 8513 Insert and 1026 Three Jaw Puller (Fig. 83).
INSTALLATION
CAUTION: To prevent severe damage to the Crankshaft, Damper or Special Tool 8512-A, thoroughly clean the damper bore and the crankshaft nose
before installing Damper.
1. Align crankshaft damper slot with key in crankshaft. Slide damper onto crankshaft slightly.
CAUTION: Special Tool 8512-A, is assembled in a specific sequence. Failure to assemble this tool in this sequence can result in tool failure and
severe damage to either the tool or the crankshaft.
2. Assemble Special Tool 8512-A as follows, The nut is threaded onto the shaft first. Then the roller bearing is placed onto the threaded rod (The
hardened bearing surface of the bearing MUST face the nut). Then the hardened washer slides onto the threaded rod (Fig. 84). Once assembled
coat the threaded rod's threads with Mopar Nickel AntiSeize or (Loctite No. 771).
