Durango 2WD V8-4.7L VIN N (2001)
2.
Locate the unused electrical connector under the driver's seat near the transmission tunnel (Figure 1).
NOTE:
If the male side of the unused connector is missing, order male connector CBDPF422 for 2001 model year vehicles or CBDPF423 for
2002/2003 model year vehicles.
3.
Slide the red locking tab towards the driver's side of the vehicle to release the primary lock on the connector.
4.
Squeeze the tail end of the male connector to release the secondary connector lock and pull the connector apart.
5.
Inspect the wiring harness side of the connector for corrosion and/or debris. If corrosion and/or debris is found, use Electrolyte Detection and
Neutralizing Spray (P/N CBEJD201) to clean the corrosion and/or debris from the connector.