Durango 2WD V8-4.7L VIN N (2001)
Valve Body: Service and Repair
Disassemble & Assemble
Disassembly
DISASSEMBLY
1. Remove the screws holding the solenoid and pressure switch assembly to the valve body (Fig. 123). Do not remove the screws on the top of the
solenoid and pressure switch assembly.
2. Separate the solenoid and pressure switch assembly from the valve body.
3. Remove the screw holding the detent spring (Fig. 124) onto the valve body.
4. Remove the detent spring from the valve body.
5. Remove the TRS selector plate from the valve body and the manual valve.
6. Remove the clutch passage seals from the valve body, if necessary.