Durango 2WD V8-4.7L VIN N (2001)
19. Remove the collapsible preload spacer (Fig. 51).
20. Remove rear bearing from the pinion (Fig. 52) with Puller/Press C-293-PA and Adapters C-293-47.
21. Remove depth shims from the pinion shaft and record shim thickness.
INSTALLATION
NOTE: The ring gear and pinion are serviced in a matched set. Do not replace the pinion without replacing the ring gear. If ring and pinion gears or
bearings are replaced, Refer to Adjustments for Pinion Gear Depth Setting.
1. Apply Mopar(R) Door Ease or stick lubricant to outside surface of bearing cup.
