Durango 2WD V8-4.7L VIN N (2001)
Seals and Gaskets: Service and Repair
Rear Axle - 8 1/4
PINION SEAL REMOVAL
1. Raise and support the vehicle.
2. Mark the universal joint, companion flange and pinion shaft for installation reference.
3. Remove companion Range bolts and secure the shaft in an upright position to prevent damage to the rear universal joint.
4. Remove the wheel and tire assemblies.
5. Remove brake drums to prevent any drag.
6. Rotate companion flange three or four times and verify flange rotates smoothly.
7. Measure rotating torque of the pinion with a inch pound torque wrench and record the reading for installation reference.
8. Install bolts into two of the threaded holes in the companion flange 180° apart.
9. Position Holder 6719 against the companion flange and install a bolt and washer into one of the remaining threaded holes. Tighten the bolts so the
Holder 6719 is held to the flange.
10. Remove the pinion nut and washer.
11. Remove companion flange with Remover C-452 (Fig. 21).
12. Remove pinion seal with a pry tool or slide hammer mounted screw.
INSTALLATION
NOTE: The outer perimeter of the seal is pre-coated with a special sealant.
1. Apply a light coating of gear lubricant on the lip of pinion seal.