Durango 2WD V8-4.7L VIN N (2001)
Wiper Relay: Service and Repair
Front Wiper Relay Replacement
REMOVAL
1. Disconnect and isolate the battery negative cable.
Fig. 10 Power Distribution Center - Typical
2. Remove the cover from the Power Distribution Center (PDC).
3. See the fuse and relay layout label affixed to the underside of the PDC cover for front wiper relay identification and location.
4. Remove the front wiper relay by grasping it firmly and pulling it straight out from the receptacle in the PDC.
INSTALLATION
1. See the fuse and relay layout label affixed to the underside of the PDC cover for the proper front wiper relay location.
2. Position the front wiper relay in the proper receptacle in the PDC.
3. Align the front wiper relay terminals with the terminal cavities in the PDC receptacle.
4. Push firmly and evenly on the top of the front wiper relay until the terminals are fully seated in the terminal cavities in the PDC receptacle.
5. Reinstall the cover onto the PDC.
