Durango 2WD V8-4.7L VIN N (2001)
Windshield Washer Motor: Service and Repair
Rear Washer Pump/Motor Replacement
REMOVAL
1. Disconnect and isolate the battery negative cable.
Fig. 6 Rear Washer Pump/Motor Remove/Install
2. Disconnect the headlamp and dash wire harness connector for the rear washer pump/motor from the motor connector receptacle.
3. Disconnect the washer supply hose from the barbed outlet nipple of the rear washer pump/motor and allow the washer fluid to drain into a clean
container for reuse.
4. Using a trim stick or another suitable wide flat-bladed tool, gently pry the barbed inlet nipple of the washer pump out of the rubber grommet seal
in the reservoir. Care must be taken not to damage the reservoir.
5. Remove the rubber grommet seal from the washer pump mounting hole in the washer reservoir and discard.
INSTALLATION
1. Install a new rubber grommet seal into the washer pump mounting hole in the washer reservoir. Always use a new rubber grommet seal on the
reservoir.
2. Position the barbed inlet nipple of the washer pump to the rubber grommet seal in the reservoir.
3. Using hand pressure, press firmly and evenly on the washer pump until the barbed inlet nipple is fully seated in the rubber grommet seal in the
washer reservoir mounting hole.
4. Reconnect the rear washer hose to the barbed outlet nipple of the rear washer pump.
