Durango 2WD V8-5.2L VIN Y (1999)
Antenna: Service and Repair
WARNING: ON VEHICLES EQUIPPED WITH AIR-BAGS, REFER TO RESTRAINT SYSTEMS BEFORE ATTEMPTING ANY
STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE
THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIR-BAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
REMOVAL
Antenna Body And Cable
1. Disconnect and isolate the battery negative cable.
2. Remove the trim cover from the right cowl side inner panel.
Antenna Cable Routing
3. Reach under the instrument panel below the glove box to access and disconnect the antenna coaxial cable connector. Disconnect the connector
by pulling it apart while twisting the metal connector harness. Do not pull on the cable.
4. Disengage the antenna coaxial cable from the retainer clips on the lower instrument panel reinforcement and the heater-A/C housing.
5. Disengage the antenna coaxial cable retainers at the right cowl side inner panel and inside the right front fender.
Antenna Mast Remove/Install - Typical
6. Unscrew the antenna mast from the antenna body.