Durango 2WD V8-5.2L VIN Y (1999)
Headlamp Switch: Service and Repair
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIRBAG AND SEAT BELTS/AIR BAGS BEFORE ATTEMPTING
ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO
TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the cluster bezel from the instrument panel. Refer to Cluster Bezel Replacement for the procedures.
Headlamp Switch Remove/Install
3. Remove the three screws that secure the headlamp switch to the instrument panel.
4. Pull the headlamp switch away from the instrument panel far enough to access the instrument panel wire harness connectors.
5. Disconnect the two instrument panel wire harness connectors from the headlamp switch connector receptacles.
6. Remove the headlamp switch from the instrument panel.
INSTALLATION
1. Position the headlamp switch to the instrument panel.
2. Reconnect the two instrument panel wire harness connectors to the headlamp switch connector receptacles.
3. Install the headlamp switch into the instrument panel.
4. Install and tighten the three screws that secure the headlamp switch to the instrument panel. Tighten the screws to 2.2 Nm (20 in. lbs.).
5. Install the cluster bezel onto the instrument panel. Refer to Cluster Bezel Replacement for the procedures.
6. Reconnect the battery negative cable.
