Durango 2WD V8-5.2L VIN Y (1999)
Fuel Tube And Clamp-TYPICAL
4. Gently cut old fuel tube (line) clamp taking care not to damage plastic fuel tube. Remove and discard old fuel tube clamp.
5. Remove plastic fuel tube from filter/regulator by gently pulling downward. Remove filter/regulator from fuel pump module.
INSTALLATION
1. Install a new clamp over plastic fuel tube.
Tightening Fuel Filter Tube Clamp-TYPICAL
2. Install filter/regulator to fuel tube. Rotate filter/regulator in fuel tube (line) until it is pointed towards front of tank (or front of vehicle).
3. tighten line clamp to fuel line using special Hose Clamp Pliers number C-4124 or equivalent. Do not use conventional side cutters to tighten this
type of clamp.
4. Press filter/regulator (by hand) into rubber grommet.
5. Rotate filter/regulator until pointed towards front of vehicle.
6. Install fuel tank. Refer to Fuel Tank Removal/ Installation.
7. Check for fuel leaks.
