Durango 2WD V8-5.2L VIN Y (1999)
Rack & Pinion Steering Gear
6. Remove the mounting bolts from the gear to the front crossmember and remove the gear.
INSTALLATION
NOTE: Before installing gear inspect bushings and replace if worn or damaged.
1. Install gear on front crossmember and tighten mounting bolts to 230 Nm (170 ft. lbs.).
2. Slide shaft coupler onto gear and tighten bolt to 49 Nm (36 ft. lbs.).
3. Clean tie rod end studs and knuckle tapers.
4. Install tie rod ends into the steering knuckles and tighten the nuts to 88 Nm (65 ft. lbs.). Install new cotter pins.
5. Install power steering lines to steering gear.
6. Remove support and lower vehicle.
7. Fill system with fluid and perform Power Steering Pump Initial Operation.
8. Adjust the toe position.
