Durango 2WD V8-5.2L VIN Y (1999)
Windshield Washer Reservoir: Service and Repair
Rear Washer Reservoir Fill Cup
REMOVAL AND INSTALLATION
1. Remove the washer reservoir from the passenger compartment.
2. Securely tie a suitable length of cord or twine to the washer reservoir end of the vent hose. This cord is to be used to "fish" the vent hose back
through the right liftgate opening pillar during reinstallation. If this method is not used, the right outboard seat belt retractor assembly for the third
seat (if the vehicle is so equipped) may have to be removed in order to properly route the vent hose through the pillar.
3. Pull the fill cup away from the right liftgate opening pillar drain channel to unseat it.
4. Remove the fill cup, fill hose and vent hose from the pillar as a unit.
5. Reverse the removal procedures to install. Be certain that the fill hose and vent hose are connected to the reservoir before seating the fill cup to the
pillar.
