Durango 2WD V8-5.7L (2008)
Hood Sensor/Switch (For Alarm): Service and Repair
Hood Ajar Switch - Removal
SWITCH
1. Unlatch and open the hood.
2. Disconnect and isolate the battery negative cable.
3. From the top of the left front fender inner shield, squeeze the two hood ajar switch latch tabs (1) together and pull the switch upward out of the
mounting hole (2).
4. Pull the hood ajar switch up through the hole far enough to access and disconnect the wire harness connector (3) from the switch connector
receptacle.
5. Remove the hood ajar switch from the vehicle.