Durango 2WD V8-5.7L (2008)
6. Apply adhesive tape strips (1) around the perimeter of the liftgate opening to aid in installation.
NOTE: Windshield installation shown, backlite similar.
7. Verify the backlite gap is parallel to with the liftgate opening.
8. Cut tape with a sharp knife and remove backlite.
NOTE: Typical primer installation shown.
9. Clean and dry area of glass (2) to be re-glued with a suitable glass preparation solvent and rag.
10. Using a flash light, verify that glass primer is without damage.
11. Re-prime any damaged area. If old adhesive has been exposed for more than 12 hours, entire adhesive area needs to be re-primed.
12. Apply primer (1) around the perimeter of the glass to a width of 15 mm (0.5 in.) (2).
13. Allow primer to air dry for at least 10 minutes.
14. Using a flash light, verify that glass primer is without damage.
Glass Preparation - Installing A New Backlite
