Durango 2WD V8-5.7L (2008)
Momentary contact push button switch/modules (2) mounted in the front face of the second row center floor console (3) operate the heated second row
seat system. Each heated seat switch/module has two Light-Emitting Diode (LED) indicator lamps, which indicate the selected level (Low or High) of
the seat heater. Pressing the switch/module button initiates heat. Heat remains on until switched off or until the ignition is turned off. If switched off by
the ignition, a switch/module button must be pressed to restart heating.
The switch/modules contain the solid state electronic control and diagnostic logic circuitry for the heated second row seat system. If any of the heated
second row seat elements are inoperative or damaged one or more of the LED lamps in the switch/module for the effected seat will flash.
The LED indicator lamps in each heated seat switch/module cannot be repaired. If the LED lamps are inoperative or damaged, or the switch/module is
inoperative or damaged the individual heated seat switch/module assembly must be replaced. See: Service and Repair/Heated Seat Switch - Removal for
the switch/module replacement procedure.
