Durango 2WD V8-5.7L (2008)
Lateral Accelerometer: Service and Repair
Installation
INSTALLATION
1. Install the dynamics sensor (2) on the studs (4) to the vehicle.
NOTE: Make sure the electrical connector is facing toward the rear of the vehicle.
2. Connect the electrical connector (3) to the sensor (2).
3. Install the two retaining nuts (1) and tighten to 6 Nm (53 in. lbs.).
4. Install the floor console See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Floor Console - Installation.
5. Perform the ABS verification test with the scan tool.
