Durango 2WD V8-5.7L (2008)
Oil Pan: Service and Repair
Engine Oil Pan - Installation
INSTALLATION
1. Clean the oil pan gasket mating surface of the block and oil pan.
NOTE: Mopar(R) Engine RTV must be applied to the 4 T-joints (1,2), (area where front cover, rear retainer, block, and oil pan gasket
meet). The bead of RTV should cover the bottom of the gasket. This area is approximately 4.5 mm x 25 mm in each of the 4 T-joint
locations.
2. Apply Mopar(R) Engine RTV at the 4 T- joints.
NOTE: When the oil pan is removed, a new integral windage tray and gasket assembly must be installed. The old gasket cannot be reused.
3. Install a new integral windage tray and gasket.
4. Reinstall the oil pump pickup tube with new o-ring. Tighten tube to pump fasteners to 28 Nm (250 in. lbs.).
